Low profile compression load cell 2KN 1KN 500N compression force measurement

Compression load cell compression force measurement

compression load cell


load cell datasheet

  • CE certified
  • Aluminum construction,low profile design,easy to install
  • Strain gauge technology,analog output
  • Temperature compensated,high performance
  • Compression force measurement

compression force measurement FCB-A
 compression force sensor

Rated capacity 500N 1KN 1.5KN 2KN
Rated output 1.5mV/V,0-5V,0-10V,4-20mA
Excitation 5-15V
Zero balance ±5% of R.O.
Nonlinearity ±0.2% of R.O.
Hysteresis ±0.2% of R.O.
Nonrepeatability ±0.1% of R.O.
Creep(30min) ±0.1% of R.O.
Safe overload 150% of F.S.
Ultimate overload 200% of F.S.
Compensated temperature -10...+40oC
Operating temperature -20...+60oC
Temperature shift zero ±0.05% R.O./10oC
Temperature shift span ±0.05% R.O./10oC
Input resistance 750±30 ohms
Output resistance 700±10 ohms
Insulation resistance >2000M ohms
Ingress protection IP50
Material of element Aluminum alloy
Cable Ø4*2000mm(Longer cable available)
Wiring code

Red--Exc+   Black--Exc-
Green--Sig+ White--Sig-

compression force measurement

A compression load cell is a compression type transducer that converts compressive force acting on it into electronic signal which is proportional to the force being applied.The measured force causes deformation of the measuring element(elastic body),the bonded strain gauge deforms accordingly which will cause the resistance change of the wheatstone bridge,under constant power supply,the output signal between Sig+ and Sig- will change proportionally,thus the force can be measured by measuring the output signal from the load cell.
A strain gauge load cell normally outputs millivolt signal ranging 0-20mV(-20~20mV for bidirectional sensor),and signal amplification may be required for most applications,a load cell signal transmitter can be used to get ±5V,±10V,0-5V,0-10V or 4-20mA signal for easy data acquisition afterwards.

load cell 4-20mA
Weight indicator can be used to display the measured value,load cell display FPT is integrated with high accuracy 24 bit Sigma-Delta ADC,sampling speed up to 960Hz,supports RS485 or RS232 communication port,can also output 0-5V,0-10V,0-20mV or 4-20mA amplified signal.
compression load cell

load cell ce certified


Other products

Call Us
Contact Supplier
Change Language