Press force sensors 20KN 10KN 5KN 2KN 1KN force transducers

Press force sensors tension compression force transducers

force measurement sensor

load cell datasheet
Features

  • Stainless steel construction,inline structure
  • M12 threaded rods on both sides,easy to install
  • Strain gauge technology,analog output
  • Push force measurement/pull force measurement
  • Widely used for force overload protection,press-in force measurement,cylinder push pull force measurement,auto equipment,production line,press machine.etc.

Dimensions(unit in "mm")
force measurement transducer
 
Specifications

Rated capacity  1KN 2KN 5KN 10KN 20KN
Rated output  1.5mV/V
Excitation  5-15V
Zero balance  ±2% of R.O.
Nonlinearity  ±0.5% of R.O.
Hysteresis  ±0.5% of R.O.
Nonrepeatability  ±0.2% of R.O.
Creep(5min)  ±0.1% of R.O.
Safe overload  150% of F.S.
Ultimate overload  200% of F.S.
Compensated temperature  -10...+40oC
Operating temperature  -20...+60oC
Temperature shift zero  ±0.01% R.O./oC
Temperature shift span  ±0.01% R.O./oC
Input resistance  385±30 ohms
Output resistance  350±5 ohms
Insulation resistance  >5000M ohms
Ingress protection  IP66
Material of element  Stainless steel
Cable  Ø5*1500mm(Longer cable available)
Wiring code

 Red--Exc+   Black--Exc-
 Green--Sig+ White--Sig-

 
 

A load cell is a transducer that converts load or force acting on it into electronic signal which is proportional to the applied force.The acting force causes deformation of the measuring element,the bonded strain gage deforms accordingly which will cause the resistance change of the wheatstone bridge,under constant power supply,the output signal between Sig+ and Sig- will change proportionally,thus the load/force can be measured by measuring the output signal from the load cell.

force measurement transducer

Tension and compression force transducer FL51 is designed to measure both tension force and compression force,outputs millivolt signal ranging -20~20mV, and signal amplification may be required for most applications, a load cell signal conditioner can be used to get -5~5V, 0-10V or 4-20mA signal which is proportional to applied force.The amplified output is can be easily processed by PLCs and data acquisition software.

force measurement sensor
The applied force can be displayed through a load cell indicator,force indicator FPT is integrated with high accuracy/low noise 24 bit Sigma-Delta ADC,sampling speed up to 960Hz makes it suitable for both static and dynamic measurement; FPT also supports Modbus RTU protocol with RS485 or RS232 communication port,amplified signal 0-5V,0-10V,0-20mV or 4-20mA is also achievable from FPT.

force transducer ce certified

Products

Compression load cell

Call Us
Contact Supplier
Change Language